8
www.barbecook.com
6.3.1 C
OUPLING
A
You need a 19 mm spanner and a cross-slotted screwdriver.
1
Screw the coupling on the gas tube of the appliance (A) and
tighten it with a 19 mm spanner (B).
2
Slide the hose over the coupling (C) and tighten the
clamping ring with a cross-slotted screwdriver (D).
6.3.2 C
OUPLING
B
You need a 22 mm spanner and an adjustable spanner.
1
Screw the coupling on the gas tube of the appliance (A) and
tighten it with a 22 mm spanner (B).
2
Screw the gas hose on the coupling (C) and tighten it with
two spanners. Hold the coupling with a 22 mm spanner,
while turning the hose with an adjustable spanner (D).
6.4 Connecting the hose and cylinder to
the regulator
Depending on the type of pressure regulator you use, you need a
cross-slotted screwdriver and/or an adjustable spanner.
1
Connect the hose to the pressure regulator. Do one of the
following:
•
If the hose has a clamping ring, slide the hose over the
regulator and tighten the clamping ring with a
cross-slotted screwdriver (A).
•
If the hose has a nut, screw the hose on the regulator and
tighten the nut with an adjustable spanner (B).
2
Connect the pressure regulator to the gas cylinder. Do one of
the following:
•
If the regulator has a nut, screw the regulator clockwise
on the cylinder and tighten the nut with an adjustable
spanner (C).
•
If the regulator has a screw thread, screw the regulator
counter-clockwise on the cylinder (D).
6.5 Replacing the cylinder
1
Close the gas supply and set all control knobs to OFF.
2
Disconnect the empty cylinder and connect the full cylinder.
3
Check the cylinder, the hose and all gas connections for
leaks. See “7 Checking for gas leaks”.
A
B
A
B
C
D
A
B
C
D
A
B
C
D
MAN_GAS_SPRING_300_300_CREME_330_350_BBC_150930_B.book Page 8 Wednesday, September 30, 2015 4:48 PM
