www.baratza.com
rev. 10/23/2018
9.
There should be a metal washer on the planet carrier (as shown in fig.1 below). Put the
large end of the planet carrier (with the three little planet gears) into the motor mount so that the
three planet gears engage securely with the teeth on the motor mount (fig. 2). This may take
some wiggling and adjusting of the individual planet gears to get them all aligned properly.
When aligned, all gears will be flush with each other.
10.
Now you are ready to attach the new gearbox onto the motor. It is easiest to do this with the
motor in the vise (wrapped in a towel). Properly align the gearbox with the motor mount and
press them together until all four clips click into locked position.
11.
Use the hex key (or a Torx bit) to screw in the two Torx-head screws included in the kit.
12.
Put the motor/gearbox assembly back into the grinder. If you need assistance,
13
. Remove one shim from under the Sette cone burr. For reference on how to do this, please see
our shim removal video guide:
https://www.youtube.com/watch?v=7sBpJcsF7-4
If you find
that your grind is too coarse after removing a shim, replace the shim.
New metal washer
Align teeth
