24
Baracuda XA Robotic Pool Cleaner
| Installation & Operating Instructions
MAINTENANCE
1
APPLIANCE BEHAVIOUR
• If a problem occurs, before you contact your retailer, please
carry out these few simple checks using the following tables.
• If the problem persists, contact your retailer.
ACTIONS TO BE PERFORMED BY A QUALIFIED TECHNICIAN ONLY.
Part of the pool is not
cleaned correctly
• Repeat the immersion steps (see section on “Immersing the cleaner”),
varying the immersion location until you find the right place in the pool.
• The positioning of the cable can limit the cleaner’s movement: check that
enough cable is unrolled into the pool and that the rest of the cable is
laid out by the pool side.
• The filter is full or dirty: clean it.
The appliance does
not stay firmly on the
pool floor
• There is still air in the appliance’s casing. Repeat the immersion
operations (see section on “Immersing the cleaner”).
• The filter is full or dirty: clean it (see section on “Cleaning the filter”).
• If the filter remains clogged despite cleaning: replace it.
• The impeller is damaged. Contact your retailer.
The appliance does not
climb the walls
• Contact your retailer.
The appliance no longer
climbs the pool walls as
it originally did
• The filter is full or dirty: clean it.
• The filter is clogged: change it.
• The tracks are slack: contact your retailer to replace them.
• Debris/objects prevent the bypass from operating: contact your
retailer to clean the bypass.
• Even though the water seems clear, microscopic algae are present in
your pool. They are not visible to the naked eye, and they make the
walls slippery and prevent the appliance from climbing. Carry out shock
chlorination and slightly reduce the pH.
Do not leave the appliance in
the water during shock treatment.
The appliance does not
move on start-up
• Check that the control box’s power socket is receiving a power supply.
• Check that a cleaning cycle has been launched and that the lights are on.
The cable gets tangled
• Unroll as much cable as possible in the pool and lay the rest by the pool
side.
The control box does
not respond to any
button presses
• Unplug the power cord from the mains socket, wait 10 seconds and plug
it back in again.
If the problem persists, contact your retailer.
