14
Baracuda XA Robotic Pool Cleaner
| Installation & Operating Instructions
CHOICE OF CLEANING MODE
LAUNCHING THE CLEANING CYCLE
• The cleaning mode defines the surface to be cleaned and the duration
of the cleaning cycle.
• By default, a cleaning mode "Floor + walls + water line" is pre-config-
ured (the symbols are lit).
• The cleaning cycle can be modified before the appliance starts or while
it is operating. The new mode will be started immediately and the
remaining time from the previous cycle will be reset.
For dual-filtration models, launch several cycles without
the very fine debris filter to pre-clean the pool.
PRESS
Floor only
Floor + walls + waterline
Surface to be cleaned
PRESS
The cleaner adapts its movement strategy to the cleaning mode, in order to
optimise its level of coverage.
Tip to improve cleaning performance
- At the start of the bathing season, launch several cleaning cycles in bottom
only mode (after removing the large debris with a net).
- Regular use of the cleaner (without exceeding 3 cycles per week) means that
your pool will always be clean and the filter less clogged.
