1
I
Overview
Introduction
Thank you for selecting the BI-650 industrial conductivity controller.
This user manual provides a step-by-step guide to help you operate
.
the meter, please carefully read the following instructions before use.
Environmental Conditions
Before the installation, ensure that current environmental conditions
meet the following requirements.
•
Relative humidity is less than 80%
•
Ambient temperature between 5° C (41° F) and 50° C (122° F)
•
No potential electromagnetic interference
•
No corrosive gas exists
Packing List
The following list describes all components of the meter. If any items
are missing or damaged, contact the supplier immediately.
BI-650 conductivity controller
IE-50MT industrial conductivity electrode
Conductivity standard solution 1413 µ S/cm
Installation
Safety Warning
•
BI-650 meter shall be installed and operated only in the manner
specified in this user manual.
•
Only skilled, trained or authorized person should carry out
installation, setup and operation of meter.
•
The rear panel of meter has two screw terminals for connecting
the 24V DC power supply. Make sure to cut off the main power
before installation and maintenance.
•
Once the power supply cable is connected to the meter, DO NOT
touch any screw terminals.
Installing the Meter
1.1 Cut out a square hole approximately 91 × 91 mm (3.58 × 1.58 in.)
in the mounting panel.
1.2 Remove the mounting bracket, place the meter into the square
hole.
1.3 Replace the mounting bracket and push the meter forward until
it is fully seated on the mounting plate.
Installing the Electrode
2.1 Wrap Teflon tape to the electrode body threads.
2.2 Insert the electrode into the mounting position and slowly turn
clockwise until secure. Hand tighten the electrode to prevent
liquid leakage.
Selectable mounting positions.
The arrow represents the direction of the liquid flow.
91 mm
91
mm
Mounting bracket
