Wiring Your SureCross
®
Device
Use the following wiring diagrams to first wire the sensors and then apply power to the SureCross devices.
5-pin Euro-Style Hookup
Wiring the 5-pin Euro-style connector depends on the model and power requirements of the device. Connecting dc power to the commu-
nication pins will cause permanent damage.
Wire No.
Wire Color
Description
1
2
3
4
5
1
Brown
10 to 30V dc
2
White
RS485 / D1 / B / +
3
Blue
dc common (GND)
4
Black
RS485 / D0 / A / –
5
Gray
Comms Gnd
DX80...C Wiring
Wiring power to the DX80...C models varies depending the power requirements of the model. Connecting dc power to the communication
pins (Tx/Rx) will cause permanent damage. For FlexPower devices, do not apply more than 5.5V to the gray wire.
Terminal Label Gateway, DX85
10 to 30V dc Powered Nodes
Battery Powered Nodes
V+
10 to 30V dc
10 to 30V dc
Tx/+
RS485 / D1 / B / +
V-
dc common (GND)
dc common (GND)
dc common (GND)
Rx/-
RS485 / D0 / A / -
B+
3.6 to 5.5V dc
Terminal Blocks
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
IP67 Housings
IP20 Housings
PWR
GND
CM4
CM3
AO4
AO3
AO2
AO1
PWR
GND
CM2
CM1
AI4
AI3
AI2
AI1
AI1
AI2
AI3
AI4
V-
V-
V-
V-
V+
V+
V+
V+
AO1
AO2
AO3
AO4
Tx/+
Rx/-
AIx or Ax. Analog IN x.
AOx. Analog OUT x.
CMx. Serial interface connection. For non-serial in-
terface models, do not make any wiring connections
to these terminals.
GND. Ground/dc common connection.
PWR. Power, 10 to 30V dc power connection.
RX/-. Serial comms line
TX/+. Serial comms line
V+. Power, 10 to 30V dc power connection.
V-. Ground/dc common connection.
Wiring Diagrams for Analog Inputs
Connecting dc power to the communication pins will cause permanent damage. Do not exceed analog input ratings for analog inputs.
Only connect sensor outputs to analog inputs.
SureCross DX80 Gateway
4
www.bannerengineering.com - tel: 763-544-3164
P/N 136325 Rev. F