Operating
Conditions
4
–40 °C to +85 °C (–40 °F to +185 °F) (Electronics); –20 °C to +80 °C (–4 °F to
+176 °F) (LCD)
95% maximum
relative
humidity (non-condensing)
Radiated Immunity: 10 V/m (EN 61000-4-3)
Shock and
Vibration
IEC 68-2-6 and IEC 68-2-27
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration:
0.5 mm p-p, 10 to 60 Hz
Certifications
Certifications
for DX8x...C (External Wiring Terminal) and DX8x...E Models
CSA: Class I Division 2 Groups ABCD, Class I Zone 2 AEx/Ex nA II T4 —
Certificate:
1921239
ATEX: II 3 G Ex nA IIC T4 Gc (Group IIC Zone 2) —
Certificate
LCIE 10 ATEX
1012 X
Refer to the Class I Division 2/Zone 2 control drawings (p/n
wiring
specifications
or
limitations.
All
battery-powered
devices must only
use the lithium
battery
manufactured by Xeno, model XL-205F.
Required Overcurrent
Protection
WARNING: Electrical
connections
must be made
by
qualified
personnel in accordance with local
and
national
electrical codes and
regulations.
Overcurrent
protection
is required to be provided by end product
application
per the supplied table.
Overcurrent
protection
may be provided with external fusing or via Current
Limiting,
Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For
additional
product support, go to
.
Supply Wiring (AWG)
Required Overcurrent
Protection
(Amps)
20
5.0
22
3.0
24
2.0
26
1.0
28
0.8
30
0.5
Warnings
Install and properly ground a
qualified
surge suppressor when installing a remote antenna system. Remote antenna
configurations
installed without surge suppressors invalidate the
manufacturer's warranty. Keep the ground wire as short as possible and make all ground
connections
to a single-point ground system to ensure no ground loops are created. No surge
suppressor can absorb all lightning strikes; do not touch the Sure Cross
®
device or any equipment connected to the Sure Cross device during a thunderstorm.
Exporting
Sure Cross
®
Radios. It is our intent to fully comply with all
national
and regional
regulations
regarding radio frequency emissions. Customers who want to re-export this product to a
country other than that to which it was sold must ensure the device is approved in the
destination
country. A list of approved countries appears in the Radio
Certifications
section
of the
product manual. The Sure Cross wireless products were
certified
for use in these countries using the antenna that ships with the product. When using other antennas, verify you are not
exceeding the transmit power levels allowed by local governing agencies. Consult with Banner Engineering Corp. if the
destination
country is not on this list.
Banner Engineering Corp. Limited Warranty
Banner Engineering Corp. warrants its products to be free from defects in material and workmanship for one year following the date of shipment. Banner Engineering Corp. will repair or
replace, free of charge, any product of its manufacture which, at the
time
it is returned to the factory, is found to have been
defective
during the warranty period. This warranty does not cover
damage or liability for misuse, abuse, or the improper
application
or
installation
of the Banner product.
THIS LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESS OR IMPLIED (INCLUDING, WITHOUT LIMITATION, ANY WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE), AND WHETHER ARISING UNDER COURSE OF PERFORMANCE, COURSE OF DEALING OR TRADE USAGE.
This Warranty is exclusive and limited to repair or, at the
discretion
of Banner Engineering Corp., replacement. IN NO EVENT SHALL BANNER ENGINEERING CORP. BE LIABLE TO BUYER OR ANY
OTHER PERSON OR ENTITY FOR ANY EXTRA COSTS, EXPENSES, LOSSES, LOSS OF PROFITS, OR ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES RESULTING FROM ANY PRODUCT
DEFECT OR FROM THE USE OR INABILITY TO USE THE PRODUCT, WHETHER ARISING IN CONTRACT OR WARRANTY, STATUTE, TORT, STRICT LIABILITY, NEGLIGENCE, OR OTHERWISE.
Banner Engineering Corp. reserves the right to change, modify or improve the design of the product without assuming any
obligations
or
liabilities
relating
to any product previously
manufactured by Banner Engineering Corp. Any misuse, abuse, or improper
application
or
installation
of this product or use of the product for personal
protection
applications
when the
product is
identified
as not intended for such purposes will void the product warranty. Any
modifications
to this product without prior express approval by Banner Engineering Corp will void the
product
warranties.
All
specifications
published in this document are subject to change; Banner reserves the right to modify product
specifications
or update
documentation
at any
time.
Specifications
and product
information
in English supersede that which is provided in any other language. For the most recent version of any
documentation,
refer to:
.
4
Operating
the devices at the maximum
operating
conditions
for extended periods can shorten the life of the device.
Sure Cross
®
MultiHop
Data Radio
©
Banner Engineering Corp. All rights reserved
