The default scan code setting is scan code 1.
To change the scan code setting, use the following instructions.
1. Remove the DES4E-51D cordset from the sensor by loosening the two screws (#1 Phillips drive).
Note:
The screws are captive screws and should not be removed from the cordset assembly.
Figure 14. Remove the Cordset
2. Flip the cordset over to see the two switches.
Figure 15. Scan Code Switches
Scan Code 1: Both switches in the left position
Scan Code 2: Both switches in the right position (as shown)
3. Position the cordset onto the sensor.
4. Hand tighten the two screws.
S4B Safety Light Curtain
www.bannerengineering.com - Tel: + 1 888 373 6767
29
