Receiver:
1-Digit Diagnostic Display—indicates specific error, configuration conditions, or total number of
blocked beams.
Key
Description
A
Reset Indicator
B
Status indicator (Red/Green)—shows System status:
•
Reduced Resolution enabled (flashing green)
•
OSSDs are ON (green ON) or OFF (red ON)
•
The System is in Lockout condition (flashing red)
C
7-Segment Diagnostic Display indicates specific error, configuration
conditions, or number of beams blocked
D
Mute device 2 input indicator (Yellow)—shows:
•
Object detected (yellow ON)
•
Object not detected (yellow OFF)
E
Mute device 1 input indicator (Yellow)—shows:
•
Object detected (yellow ON)
•
Object not detected (yellow OFF)
F
Zone indicators (Red/Green)—each shows status of approximately 1/6 of
the total beams:
•
Aligned and clear (green ON)
•
Blocked and/or misaligned (red ON)
•
Fixed blanked area (flashing green)
G
Zone 1 Indicator—indicates beam synchronization status
A
B
C
D
E
F
G
Figure 44. Receiver
10.2.1 Emitter
A single bi-color Red/Green Status indicator shows whether power is applied, and whether the emitter is in a Run mode,
Test mode, or a Lockout. A Diagnostic Display indicates a specific error code when the emitter is in Lockout; the display
also momentarily indicates the scan code setting at power-up or when changed.
Table 4: Emitter Status Indicator Operation
Operating Status
Status Indicator
7-Segment Diagnostic Display
Power-up
Red Single Flash
Scan code flashes 3 times - sequentially
or
Run Mode
Green
Lockout
Flashing Red
10.2.2 Receiver
A single bi-color red/green Status indicator shows when the OSSD outputs are On (green) or Off (red), or the System is in
Lockout status (flashing red).
An amber status indicator shows when the system is in Run mode or is waiting for a reset.
The Diagnostic Display indicates the receiver’s trip (–) or latch (L) configuration and displays a specific error code when the
receiver is in Lockout. The Diagnostic Display also momentarily indicates the scan code and mute configuration setting at
power-up or when changed.
Amber Mute Device (MD) indicators show the status of the two mute device inputs. An amber indicator shows when the
mute device input is at +24 V DC, for example, sensor PNP output conducting.
EZ-SCREEN Low-Profile System with Integral Muting
www.bannerengineering.com - Tel: + 1 888 373 6767
71