Banner AG4 Series Safety Laser Scanner
9. Check that there is no gap of light
between the front screen and the
housing. Fix the front screen with
the fixing plates.
10. Support while screwing the fixing
plates with a little pressure on the
furthest outside edge of the front
screen.
11. Check the Scanner components
(e.g., mirror, optics, or housing
parts) for dust and blow the
Scanner down as required with a
light, oil-free stream of
compressed air.
12. Carefully put the two housing parts
back together. The two retaining
bolts must slide into the rubber
sleeves provided for this.
13. Carefully tighten the Allen screws
on the housing rear by alternating
between them.
1
Retaining bolts
2
Rubber sleeves
14. Remove any fingerprints on the
front screen.
Figure 5-5. Scanner front screen replacement procedure
5.4.5 Calibrating the Front Screen (Window)
Requirements:
The new front screen is correctly mounted.
Front screen is clean and scratch-free.
Ambient temperature: 20° C to 25° C
CAUTION . . . ENSURE FRONT SCREEN IS CLEAN
Faulty calibration may be caused by a dirty or scratched front screen.
Only calibrate front screens that are clean and free of scratches and marring.
1. Connect interface X1 with the control system.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]