8.
Plug the OBDII cable into the OBDII
port under the dash (Figure 10).
NOTE: If using the Switch
configuration, perform steps
9-11
. If using iDash 1.8" Gauge
configuration, skip to step
12
.
9.
Plug the 4-pin connector from
the OBDII cable, the 6-pin connector
from the starter cable, and the 2-pin
connector from the switch cable into
the Y-harness (Figure 11).
Figure 9
Summary of Contents for Derringer
