Bang & Olufsen Beolab transmitter 1, Manual, Page: 6 / 83

6
Make a wireless connection with a Bang &
Olufsen television
– Fill up the PL sockets on your transmitter from
the left (PL1) to the right with a subwoofer as
the last to connect. If you have a smaller setup
than described below, your speaker connections
should be moved leftwards when possible in the
Power Link sockets on the transmitter.
MONITOR PUC 2
PL 5 PL 4 CONTROL A+B
Connect the cables
…
> Make sure the television and transmitter are
disconnected from the mains.
> Connect the first two speakers by connecting
one end of a Power Link cable to the socket
marked PL1 on the transmitter and the other
end to a Power Link socket on the television that
is not predefined. If the sockets are predefined,
see the priority of connections in
“
When Power
Link sockets on your television are predefined
… ”
on this page.
> Connect the next two speakers by connecting
one end of a Power Link cable to the socket
marked PL2 on the transmitter and the other
end to a Power Link socket on the television that
is not predefined. If the sockets are predefined,
see the priority of connections in
“
When Power
Link sockets on your television are predefined
… ”
on this page.
> If you have more speakers to connect, connect
one end of a Power Link cable to the socket
marked PL3 on the transmitter and the other
end to a Power Link socket on the television that
is not predefined. If the sockets are predefined,
see the priority of connections in
“
When Power
Link sockets on your television are predefined
… ”
on this page.
Fill up the PL sockets from the left (PL1) to the right.
Four Power Link cables are shown here, which is a
full 7.1 setup
> If you have more speakers or a subwoofer to
connect, connect one end of a Power Link cable
to the socket marked PL4 on the transmitter
and the other end to a Power Link socket on the
television that is not predefined. If the sockets
are predefined, see the priority of connections
in
“
When Power Link sockets on your television
are predefined
… ” on this page.
> Connect the television, the transmitter, and the
speakers to the mains. The transmitter
’s wireless
status indicator starts flashing white, the
product status indicator on the front panel
becomes solid red for some seconds before
switching off, and the speakers
’ wireless status
indicators start flashing green, because there
are still no wireless connection between the
transmitter and the speakers.
PL 3 PL 2 PL1 PUC 3 A+B
CTRL 3
Example of cable connection between the
transmitter box and a television.
When Power Link sockets on your television are
predefined
…
Filling the PL sockets on the transmitter from the
left to the right, you must make connections to
your television in the following priority:
Television sockets
Left REAR
Right REAR
Left FRONT
Right FRONT
SUB
Note that connections from the four PL sockets on
the transmitter can only be made to four of the
above sockets on the television at a time. For
example you could connect PL1 to left REAR, PL2
to right REAR, PL3 to left FRONT and PL4 to SUB.
If only the subwoofer and centre speaker sockets
are predefined on the television, 1(SUB) should
always be chosen for the last PL socket on the
transmitter to be connected, having in mind the
sockets are filled from the left.