B&R 5PC600.SE00-00, User Manual, Page: 200 / 594

200
Technical data • Individual components
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
The cable types and resolutions shown with a footnote 2) in the previous table can only be
implemented starting with the following firmware and hardware versions:
DVI, SDL description
DVI means:
• Connection of B&R Automation Panel 900 display units with Automation Panel Link DVI
Receiver (Model nr. 5DLDVI.1000-01), Office Digital/DVI Monitors and Office DVI TFT
Displays is possible.
For examples and possibilities for connecting Automation Panel 900 display units via DVI, see
Appendix A, chapter 3 "Commissioning", section 4 "Connection examples", starting on page 215.
Firmware Name Version Note
MTCX FPGA Firmware on the APC620 v 01.15 The version is read from BIOS - see the
BIOS description.
Supported starting with the APC620 /
PPC 700 Firmware upgrade (MTCX,
SDLR, SDLT) V01.10 , available in the
download area of the B&R homepage.
MTCX PX32 Firmware on the APC620 v 01.55
SDLR FPGA Firmware on the AP Link SDL receiver and
transceiver v 01.04
SDLT FPGA Firmware on the AP Link SDL transmitter v 00.02
Hardware Name Revision Note
5DLSDL.1000-00 AP Link SDL receiver Rev. D0
5DLSDL.1000-01 AP Link SDL transceiver Rev. D0
5AC600.SDL0-00 AP Link SDL transmitter Rev. B3
5PC600.SX02-00 System 2 PCI, 1 disk drive slot, 1 AP Link slot Rev. D0
5PC600.SF03-00 System 3 PCI, 1 disk drive slot, 1 AP Link slot Rev. A0
5PC600.SX05-00 System 5 PCI, 2 disk drive slots, 1 AP Link slot Rev. C0
Table 111: Requirements for SDL cable with extender and automatic cable adjustment (equalizer)
Figure 84: AP Link device connection with DVI video signal
Automation Panel 900 Digital/DVI Monitor DVI TFT
Automation Panel Link DVI Receiver
5DLDVI.1000-01
Automation PC 620