Bandit
23
Copyright 8/19
MODEL SG-75
MACHINE OPERATION
MACHINE OPERATION
CUTTING AREA
DANGER
!
For optimum performance, the stump should be cut with the portion of the cutter wheel shown below. Never
undercut the stump. Undercutting the stump may cause severe kickback, vibration and component damage.
Never cut the stump from the top. The cutter wheel will throw debris up and toward the operator, instead of
down and under the machine.
90°
CUTTING
AREA
The stump must be cut as low to the ground as possible to reduce the amount of grinding material and
debris in the work area.
If the grinding material starts to interfere with the machine operation, follow the steps below before removing
any grinding material. Never remove any grinding material with cutter wheel running. Contact with a rotating
cutter wheel will result in serious bodily injury or death.
1. Disengage the cutter wheel.
2. Position the machine away from the stump.
3. Before attempting any type of maintenance, disengage clutch or cutter wheel engagement, wait for the
cutterwheeltocometoacompletestop,positionandlockthecutterwheelinthetransportposition,turnoff
engine, remove the ignition key, make sure the ignition key is in your possession, install the cutter wheel lock
pin, wait 2 minutes then disconnect the battery.
4. Clear the grinding material away from the stump.
5. Start the machine and reposition it at the stump before engaging the cutter wheel.
DANGER
!
