Bandit SG-75, Operating & Parts Manual

Page: 41 / 60

Bandit
39 Copyright 8/19
MODEL SG-75
Some equipment and components such as
fl­uid­engagement­clutch’s­(PTO’s)­have­their­own­
lubrication requirements. Consult their manufactures
manual for that information.
Do not under any circumstances over-set relief
pressures, it will cause damage to component and
hydraulic parts.
­ These­typical­hydraulic­fl­ows­and­relief­pressure­
settings are with the engine at full RPM. All settings
are subject to change.
When returning hydraulic components for
warranty make sure to box up all warranted parts
to avoid additional damage while shipping.
Do
not disassemble any hydraulic components
which are to be warranted. Anything which has
been disassembled or tampered with will not be
warranted. Items being returned must be clean. All
hydraulic components must have all hosing ports
plugged. Failure to plug ports will allow debris to
enter components which will void warranty.
DO NOT operate this machine unless all hydraulic
control devices operate properly. They must function,
shift and position smoothly and accurately at all
times. Faulty controls can cause personal injury!
It is very important after you have operated a new
machine for approximately an hour to shut down the
machine­and­recheck­all­hydraulic­fi­ttings.­Relieve­all­
pressure and retighten as needed.
DO NOT GO NEAR HYDRAULIC LEAKS! High
pressure oil easily punctures skin causing serious injury,
­gangrene,­or­death.­Avoid­burns­from­fl­uid.­Hot­fl­uid­
under pressure can cause severe burns. DO NOT use
fi­ngers­or­skin­to­check­for­leaks.­Lower­load­or­relieve­
hydraulic­pressure­before­loosening­fi­ttings.­Relieve­
all pressure in the system before disconnecting the
lines, hoses, or performing other work. Use a piece of
­cardboard­to­fi­nd­leaks.­Never­use­your­bare­hands.­
Allow system to cool down to ambient temperature
before opening any coolant or hydraulic oil system.
In cold weather situations let your hydraulic system
idle for approximately 15 minutes to allow the system
to warm up to operating temperature.
HYDRAULICS
HYDRAULICS
NOTICE
WARNING
!
WARNING
!
NOTICE
NOTICE
NOTICE
After the initial start-up of the machine and after
any­replacement­of­­hydraulic­components,­fi­ttings­
and hoses must be re-checked for leaks and
clearances.
CAUTION
!
DANGER
!
Before attempting any type of maintenance,
disengage clutch or cutter wheel engagement, wait
for the cutter wheel to come to a complete stop,
position and lock the cutter wheel in the transport
position,­ turn­ off­­ engine,­ remove­ the­ ignition­ key,­
make sure the ignition key is in your possession,
install the cutter wheel lock pin, wait 2 minutes then
disconnect the battery.
HYDRAULICS