BANDIT CONTROLS
10
245774458290 21Dec2016
Setup Page (Password protected)
1. Select down to the parameter you wish to adjust.
2. & 3. Increase or decrease the value of the selected parameter, or select through various options.
4. Go to Factory Settings (password protected).
5. Go back.
AutoFeed
During normal operation the feed system will reverse, stop, and resume based on the AutoFeed Engine Speed
settings. In the example screen shot above,
when Eng RPM falls below AutoFeed Lo 1800rpm,
the feed wheels will briefly reverse for AutoFeed Rev Time 200ms and then stop.
The system will wait for Eng RPM to recover above AutoFeed Hi 2000rpm
and then Feed Fwd will resume.
(Note: if AutoFeed Hi setting value is mistakenly set higher than the engine can run, the Feed system will not
Feed Fwd because it is waiting for the engine to reach a speed it cannot attain. Correct the AutoFeed Hi
setting to approx 100-200rpm lower than max engine speed).
1
2
3
4
5
Fuel Saver - Behind the FuelSave Load setting (42%
as shown) is the actual Load on the engine (25% as
shown). The setting is typically 5-10% higher than
actual load at high idle with clutch engaged.
In this case we would have seen between
30-35% engine load when clutch is engaged and
engine at full speed, no material being fed. And so
42% was selected as the FuelSave Load setting; this
assumes that loads above 42% indicate material is
being fed.
Summary of Contents for INTIMIDATOR 19XPC
