Bandit
Copyright 11/10
PAGE 8
MODEL 490
MAINTENANCE SECTION
LUBRICATION CHART
NOTICE Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Lubrication & Coolant Section
and Maintenance Section of this manual, or component manufacturer’s manual.
CHECK
# DESCRIPTION
DAY WEEK MONTH PROCEDURE
1 Drum Bearings
X
Purge bearings daily - wipe off excess
2 Jack Shaft Bearings (PTO) X
Purge bearings daily - wipe off excess
3 Infeed Hopper Hinge
X
Lubricate
4 Steel Friction Areas: pivoting,
X
Lubricate (i.e. castor wheel mount bar,
hinged, sliding, rolling
discharge flipper, etc)
5 Castor Wheel Pivot Bushings
X
1 to 2 shots of grease - wipe off excess
6 Wheel Bushings
X
1 to 2 shots of grease - wipe off excess
7 Wheel Bearings (Towable)
X
Grease until full - wipe off excess
8 Discharge Swivel Plates
Months Grease as needed
9 Wheel Bearings (Towable)
Yearly Purge yearly - wipe off excess
A right angle grease fitting may need to be used to grease
some of the lubrication points. This type of grease fitting
can be obtained from most local automotive parts stores.
9
7
