B&G Hydra 2000, User Manual

Page: 69 / 147

Hydra 2000 User Manual
Part 3 - Calibration
HB-0844-02
3-13
3.4.2 Heading Node Selection
The Hydra 2000 System can accept heading data from a variety
of different sources. These different sources are known as
Address Nodes and allow the system to identify which heading
devices are connected to the system. The list below shows the
various sources of heading available with its respective address
node:
Device Node
Super Halcyon 3 Compass 5
Halcyon 2000 Compass 16
Type PLC Pilot 17
Type ACP Pilot 18
NMEA Heading (NMEA FFD) 96
Enter the required heading node by following the procedure
below:
(a) Press the Scroll Up key until NAVIGATE is shown in
the text, flashing.
(b) Press Enter .
(c) Press the Scroll Up key again until the display shows
COURSE
°
M flashing.
(d) Press Enter . COURSE
°
M will now stop flashing.
(e) Press Scroll Down until the display shows
CALBRATE.
(f) Press Enter 3 times. The display now shows HDG NO
and will display a value which flashes.
(g) Use the Scroll Up and Scroll Down keys to change
the value to the required setting.
(h) Press Enter .
(I) Switch the system off, and then back on again to
complete the calibration process.