![background image](http://html1.mh-extra.com/html/bandelin/sonorex-technik-lg-series/sonorex-technik-lg-series_user-instructions_3823955018.webp)
18 / 30
23366b GB/2019-07
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
4.2
General use
Step 1:
Check cable connections
Verify that all connecting cables and couplings are correctly connected.
Step 2:
Prepare the sonication
To do so, see the corresponding user instructions for tank baths, ultrasonic transducer
systems, or reactors.
Prepare and check the sonicating medium to verify that the
fi
ll level is correct.
Step 3:
Start ultrasound operation
Turn on the power module with the "ACTIVE" module switch.
Turn the power control dial in a counterclockwise direction (minimum power).
During operation, the control dial should be set to the desired power.
Turn on the mains switch.
The fan(s) on the rear of the generator turn(s) on.
When the power is switched on, all LEDs light up for approx. 4 seconds at the
power modules. The "TEMPERATURE" LED
fl
ashes during this time.
Turn on the HF switch (Start/Stop) on the control module.
Adjust the control dial until the light display shows the desired % value.
After a few seconds, when the power has been achieved, the "CONTROL" LED
(green) will illuminate the working power module.
If "CONTROL" is not triggered or if "TRANSDUCER" or "DRY" light up, there is an
error or incorrect adjustment (see chapter 6.2).
Step 4:
Stop ultrasound operation
In order to stop the power output, activate the HF power switch (Start/Stop).
To turn the generator off, press the mains switch - set it to "0".
For additional care instructions, see chapter 5.