![background image](http://html1.mh-extra.com/html/bandelin/sonorex-technik-lg-series/sonorex-technik-lg-series_user-instructions_3823955015.webp)
Light display
Control dial for power spec-
i
fi
cation (POWER)
HF switch
23366b GB/2019-07
15 / 30
1
electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • [email protected]
3 Operation
The generator ist operated from the front at the operating module - depending on order
at the control module SM 3 (following chapter) or at the processor module PRO 3
(separate user instructions).
If needed, the SM 3 control module can be exchanged against the PRO 3 processor
module, see chapter 7.2.2.
3.1
Control module SM 3
Light display:
- The light display will show the power that was selected using the "POWER" control
dial, at 10% intervals, even when operating the generator using the remote control
connection.
- The lowest LED will be illuminated when the generator is operating at minimum
power.
- If the HF switch is turned off, or if the power output is blocked by the remote control
connection, only one LED on the LED strip will be illuminated. It will display the
target output that was set.
- If the generator is started using the HF switch or the remote control, the LEDs below
the individual LED will also be illuminated.
- If an error occurs (see Error analysis, chapter 6.2) all LEDs illuminated up to this
point will
fl
ash at the same time.
- If the generator is externally controlled over the RS 232 interface connection, the
third,
fi
fth and seventh LEDs, starting from the top, will be illuminated.
Control dial for power speci
fi
cation:
The power is continuously adjustable from 10 to 100 %. By turning it, the power for all
modules is set at the same time.
HF switch:
Switching the power output on and off.