BANDELIN SONOREX TECHNIK HA 40, Operating Manual, Page: 15 / 24

22676-004 en/2024-01
15 / 24
5 Operation
5.1 Putting into service
The supplied O-rings are for fixing saw blades in place on the holding axle. These are not
required if a planing head is to be cleaned.
Requirements
• The mains plug needs to be plugged into an earthed wall socket.
Procedure
1. Fill the ultrasonic device with cleaning agent.
2. Place the planing head with the axle directly on the guide rollers. For planing heads
without an axle, or when cleaning saw blades, use the supplied axle.
3. The planing head must not touch the tank wall – otherwise no rotational movement is
possible.
4. The axial screws can be used to ensure that the planing head or supplied axle does not
"wander" during operation.
5. Check the filling level: is the planing head immersed in the cleaning agent?
6. Only switch on the planing head holder, using the time switch, once the planing head is
resting correctly on the guide rollers.
7. The axle of the planing head holder will begin to rotate. The continuous rotational
movement of the planing head in the ultrasonic bath supports the cleaning effect.
8. Put the ultrasonic device (RM ... UH) into operation – see separate operating
instructions.
9. Once the set time has elapsed, remove the axle with the planing head and rinse if
necessary, or repeat the cleaning process if necessary.
Operation