background image

IMPORTANT SAFETY INSTRUCTIONS

B&D Doors & Openers

 Pty Ltd 

(B&D) 

to the extent that such may be lawfully excluded hereby expressly disclaims all conditions or warranties, statutory

or otherwise which may be implied by laws as conditions or warranties of purchase of a 

B&D

 Roll

ing

 Garage Door

 

Opener. 

B&D

 hereby further

expressly excludes all or any liability for any injury, damage, cost, expense or claim

 

whatsoever suffered by any person as a result whether directly 

or indirectly from failure to install the 

B&D

 Roll

ing

 Garage Door

 

Opener in accordance with these installation instructions.

3

For  ADDITIONAL SAFETY protection we

STRONGLY recommend the fitting of a Photo Electric

Beam. In most countries Photo Electric Beams are

mandatory on all garage doors fitted with automatic

openers. For a small additional outlay B&D recommends

that Photo Electric Beams be installed with the 

automatic opener ensuring additional safety and peace

of mind.

DO NOT operate the garage door opener unless the

garage door is in full view and free from objects such as

cars and children/persons. SERIOUS PERSONAL

INJURY and/or property damage can result from failure

to follow this warning. 

DO NOT operate the garage door opener when

children/persons are near the door. Children must be

supervised near the garage door at all times when the

door opener is in use. SERIOUS PERSONAL

INJURY and/or property damage can result from failure

to follow this warning.

DO NOT allow children to operate the garage door

opener.  SERIOUS PERSONAL INJURY and/or

property damage can result from failure to follow this

warning.

Regularly check to make sure that the SAFETY

OBSTRUCTION FORCE is working correctly, and is

TESTED (by placing a 40mm high object on the floor)

and set as per the installation instruction manual. Failure

to follow the manual may result in SERIOUS 

PERSONAL INJURY and/or property damage. This

test must be repeated at regular intervals and the

necessary adjustments made as required.

DO NOT disengage the door opener to manual

operation with children/persons or any other objects

including motor vehicles within the doorway.

Install the wall switch or wall mounted transmitter in a

LOCATION/POSITION where it is out of reach of

children and the garage door is visible.

The door opener is not intended for use by young 

children or infirm persons without adequate supervision.

Young children should be supervised to ensure that they

do not play with the equipment.

Keep hands and loose clothing CLEAR of the garage

door and opener at all times.

Warning - It is vital for the safety of persons to follow all instructions. Failure to comply

with the following Safety Rules may result in serious personal injury and/or property damage.

The unit should be installed so that it is protected from

the elements. It should not be exposed to water or rain.

It is not to be immersed in water or sprayed directly by

a hose or other water carrying device.

The garage door must be WELL BALANCED.

Sticking or binding doors must be repaired by a

qualified garage door installer prior to installation of the

opener .

Frequently examine the installation, in particular

cables, springs and mountings. DO NOT attempt to

repair the door yourself as hardware is under extreme

tension and can cause SERIOUS PERSONAL

INJURY and/or property damage.

REMOVE OR DISENGAGE all garage doors locks

and mechanisms prior to installation of the opener.

Connect the garage door opener to a properly

EARTHED general purpose 240V mains power outlet

installed by a qualified electrical contractor.

DISCONNECT THE POWER CORD from mains

power before making any repairs or removing covers.

Only  EXPERIENCED service personnel should

remove covers from the garage door opener.

When using auto close mode, a PHOTO ELECTRIC

BEAM must be fitted correctly and tested for operation

at regular intervals. EXTREME CAUTION is 

recommended when using auto close mode. ALL

SAFETY RULES must be followed.

In order for the garage door opener to SENSE an object

obstructing the door way, some FORCE must be 

exerted on the object. As a result the object, door and/or

person may suffer DAMAGE or INJURY.

If the power supply cord is damaged, it MUST be

replaced by an B&D service agent or suitably qualified

person.

Make sure that the door is fully open before driving in

or out of the garage.

Make sure the door is fully closed before leaving the

driveway.

Summary of Contents for Easylifter

























Reviews: