CODING TRANSMITTERS
15
11. SETTING THE TRANSMITTER TO OPERATE THE
COURTESY LIGHT
12. ADJUSTING COURTESY LIGHT TIME
The preset courtesy light time on the Door Opener is 3 minutes.
This time can be changed as below.
1. Press and hold the Auto Close Time and Force Margin Set
buttons together (Fig. 26)
.
2. While holding the two buttons, press the green Open
button (Fig. 26). Each press will add 10 seconds to the light
time.
3. To decrease the time follow step 1 and press the red Close
button (Fig. 26). Each press will deduct 10 seconds from the
light time.
4. To recall the factory set default light time press and hold the
Auto Close Time, Force Margin Set and Reset buttons
together for about 2 seconds. (Fig. 26)
.
13. DELETING PROGRAMMED CODES
FIG. 26
FIG. 25
FIG. 27
Although the courtesy light comes on with each operation of
the opener, the courtesy light may also be controlled by a
remote control transmitter without operating the door. To code
one of the remote control transmitter buttons to turn the
courtesy light on and off:
1 - Press the Light Code button on the opener. The Light Code
LED will illuminate and courtesy light will turn on to show
that you are learning the code for controlling the courtesy
light.
2 - Choose a button on the transmitter not already coded to
operate the door and press until the Light Code LED
flashes.
3 - Press the transmitter button to test if it switches on the light.
13.1 Delete all transmitters codes from the operate channel
1. Press and hold the Door Code button for approximately six
seconds
2. The Door Code LED will blink for one second to indicate all
codes have been erased
3. Press the transmitter button to ensure it does NOT operate
the door
13.1 Delete all transmitters codes from the courtesy light
channel
1. Press and hold the Light Code button for approximately six
seconds
2. The Light Code LED will blink for one second to indicate all
codes have been erased
3. Press the transmitter button to ensure it does NOT operate
the courtesy light