Controll-A-Door
®
S & PanelPro
Instruction Manual
8
9. Mounting Brackets and Arms
Mounting The Door Bracket:
a. The door bracket locator
7
is placed over the door bracket
8
, on the door’s centre line one-third down the top panel and
mounted using M6 or equivalent screws (not supplied),
b. STEEL DOORS ONLY: Bracket can be welded in place.
NOTE:
If in doubt about the door’s strength, reinforcement
may be added to the door’s frame where necessary. Door
damage may occur if the bracket is installed on a panel
with insufficient strength. The opener’s warranty does not
cover damage caused to the door and/or door panels.
Attaching the Arms
a. Assemble the bent arm
4
(connecting to the door) to the right
side of the straight arm
5
with bolts
10
and nuts
13
supplied
in the accessory pack. Connect the straight arm
5
to the
8
7
7
12
9
4
13
6
10
9
12
8
5
10. Connect to Power
Initial Preparation:
a. Move the door to the half way position.
b. Remove the clear button cover from the unit.
NOTE:
This cover has a label that says “Do not remove” however, this
only applies during normal operation. This cover must be removed to
setup the opener.
c. Switch power on to the opener. The red CLOSE LIMIT LED will be
flashing.
d. Press and hold the MINUS (-) button - the door should start closing. If
door starts to close, release button.
NOTE:
If the door opens, release the MINUS (-) button and press the
OPERATE button once to change the motor’s direction.
shuttle with a clevis pin
12
and a pin snap
9
. Always use both bent and straight arms.
b. Connect the assembled arm to the bracket with clevis pin
12
and pin snap
9
. The angle “A” must be more than 10°.
A
