Controll-A-Door
®
S & PanelPro
Instruction Manual
6
6. Fit the Opener
Secure C-Rail to Opener:
a. Remove the Opener from the box and place onto towel.
b. Locate and insert the shaft of drive unit
1
into the C-Rail’s sprocket.
c. Fix the two track brackets
15
with four (4) M4 x 8 screws
14
supplied in accessory pack.
d. Place drive unit back in packing box for protection.
Locate shaft into
the sprocket
16
1
15
14
WARNING!
DO NOT
use tek screws to affix
rail. Only use the screws
provided, and fix these
into the pre-punched
and threaded holes in
the chassis.
7. Bracket Position
Wall Bracket Position:
a. Determine the centre of the door and mark this point with a line on the wall above.
b. Raise the door and find the highest point of travel of the first (top) door panel.
60mm
Level
WARNING!
The Opener must be securely fastened to structural
supports, otherwise opener failure may ensue causing serious personal
injury and / or property damage.
DO NOT DO IT YOURSELF:
If sufficient structural support can not be
found, contact a door profressional for installation.
DIY
c. Using step ladder and a level, transfer this height to the wall above the door and
mark a line 60mm above it, across the centre line.
Mounting The Wall Bracket:
a. Draw two lines extending 21.5mm from each side of the centre point.
b. Centre the wall bracket
6
over the intersection of these two lines. Mark
centres for at least two holes and ensure it is into a solid mounting point.
c. Drill holes in the wall with an appropriate bit.
d. Secure to the wall using:
i. IF CONCRETE OR BRICK:
8mm (5/6”) loxins/dynabolts.
ii. IF TIMBER:
wood screw #20 or similar (min. 50mm).
Attach The Rail To The Wall Bracket
a. Leave the drive unit in its packing box on the floor for protection and lift the
other end of the C-Rail.
b. Attach the C-Rail assembly
16
to the wall bracket
6
with the
90mm long pin
11
and secure with the supplied pin snap
9
.
16
11
9
6
6
CAD S
Shown