baltur GI 500 MC, Installation, Use And Maintenance Instruction Manual

Page: 64 / 76

ENGLISH
26 / 36
0006160064_201510
MAINTENANCE
Analyse combustion gases and check that the emission values
are correct at least once a year, in compliance with current law.
Carry out the following operations at the end of the heating sea-
son:
• Clean air dampers, the air pressure switch with pressure port
and the relevant pipe (if fitted).
• Check the electrode condition. Replace them, if necessary.
• Clean the photocell. Replace it, if necessary.
• Have the burner and the chimney cleaned by specialised per-
sonnel (stove repairer); a clean burner is more efficient, lasts
longer and is quieter.
• Check that the fuel filter is clean. Replace it, if necessary.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposi-
ts deriving from the installation environment and/or from poor
combustion.
If it is necessary to clean the outside of the combustion head, take
out its components according to the procedure described:
• unscrew the four anchoring screws -12, and open the ventila-
ting body;
• pull out the ignition and ionisation cables -14 from their electro-
de terminals-13;
• unscrew the ring -20 from the nipple -21;
• completely unscrew the two screws -6 and pull out the entire
mixer unit -19 in the direction shown by the arrow.
• Having completed the maintenance work, replace the combu-
stion head, following in reverse order the operations described
above, after having checked the correct position of ignition and
ionisation electrodes.
12
12
14
13
6
0002936000b
0002936000e
20
19
21