baltur 67200010, Installation, Use And Maintenance Instruction Manual

Page: 49 / 60

ENGLISH
19 / 28
0006081514_201711
MAINTENANCE
Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
Carry out the following operations at the end of the heating season:
• Clean air dampers, the air pressure switch with pressure port and
the relevant pipe (if fitted).
• Check the electrode condition. Replace them, if necessary.
• Have the burner and the chimney cleaned by specialised personnel
(stove repairer); a clean burner is more efficient, lasts longer and
is quieter.
• In order to clean the combustion head, its outlet and components
must be disassembled. Be careful during the reassembly operations
to exactly centre the gas diffuser with respect to the electrodes,
making sure that they are not earthed, which would result in the
locking of the burner. Verify also that the ignition electrode spark
takes place exclusively between itself and the perforated sheet
metal disk (see combustion head and electrode disk distance
regulation diagram) for the version without pilot.
• Analyse combustion gases and check emissions values.
• Check that all components of the combustion head are in good
condition, have not been deformed and are free from deposits
deriving from the installation environment and/or from poor
combustion.
If it is necessary to clean the combustion head, remove its components
according to the procedure described below:
• unscrew the anchoring screws -12 and open the ventilating body;
• Pull out the ignition and ionisation cables -14 from their electrode
terminals -13;
• Unscrew the screw -16 on the buffer -17;
• pull out the entire mixer unit in the direction shown by the arrow.
• When you have finished maintenance work, proceed to reassemble
the combustion head, following the same procedure in reverse,
after checking the correct position of the ignition electrodes.
12
12
14
14 13
13
16
17