31
Short instruction
2.2
Full auto teaching (with an object moving)
Î
„T
“ or „
T
V
“
must be visible in the display (set by placing slide switch to SELECT and
pressing button 1 repeatedly
)
and the slide switch must be in the „
RUN
“ position.
Î
Push button 1 and hold it down for at least 3 seconds.
Î
Allow object to pass by.
Î
Release button 1.
Î
Setting done
2.3
External Teach in
Î
The same procedure like in 2.1 and 2.2. The external Teach (Remote ) replaces button 1.
(External Teach must be connected to + U
B
at least 50 ms)
3 Manual setting
3.1
Manually setting the switching threshold
Î
„
S
“ must be visible in the display (set by placing slide switch to SELECT and pressing
button 1 repeatedly
)
and the slide switch must be in the „
MODE
“ position.
Î
If an object is placed in front of the fibre the light amount is displayed in 3 digits.
Î
The flushing digit can be increased with button 1.
Î
Push button 2 to skip to the next digit.
Î
After setting the slide switch to „
RUN
“ the device is ready.
3.2
Hysteresis selection
Î
„
H
“ must be visible in the display (set by placing slide switch to SELECT and pressing
button 1 repeatedly) and the slide switch must be in the „
MODE
“ position.
Î
The flushing digit can be increased with button 1.
Î
Push button 2 to shift digit.
Î
After setting the slide switch to „
RUN
“ the device is ready.
3.3
Timer changeover
Î
Push button 2, hold it down and turn the switch from „
RUN
“ to „
SELECT
“.
Î
The timer can be selected by pushing button 1.
Î
After selection is completed, replace the switch to „
RUN
“.
