Balluff BIS M-62 Series, Manual

Page: 34 / 198

INSTALLATION
27
2
1. Mount the processor unit Adapter to the top of the processor unit using the two
20 mm M5 screws and washers provided with each BIS M-62_ Processor unit.
2. Mount the Antenna Adapter to the bottom of the antenna as follows:
3. for Antenna models -371 , -372 , and -373 , use the two 25 mm M5 screws, washers
and nuts provided with the BIS M-500-PVC-07-A01/02 Extension Cable kit.
4. for Antenna models -370 , use the two 35 mm M5 screws provided with the
BIS M-370-000-A02 antenna. The M5 washers and nuts are in the Extension Cable
kit.
5. Connect one end of the antenna extension cable to the RF port on the top of the
Processor unit - Side Adapter, attach the other end to the RF port on the bottom of
the Antenna - Side Adapter. Tighten both ends of the extension cable firmly by hand.
6. Fasten the processor unit and the antenna to your mounting fixtures using M5 (or #10)
diameter screws (not included) and secure them with appropriate washers and nuts.
To complete the installation, refer to the specific procedure for your Processor unit under par.
2.6.
2.2.3 Minimum Mounting Distance Between Adjacent Antennas
ANT -371 -372 -373 -370
-371 60 cm 75 cm 90 cm 50 cm
-372 75 cm 90 cm 1.2 m 65 cm
-373 90 cm 1.2 m 2 m 90 cm
-370 50 cm 65 cm 90 cm 50 cm