Balluff BIS M-62 Series, Manual

Page: 49 / 198

BIS M-62_ MANUAL
42
2
2.6 TYPICAL LAYOUTS AND INSTALLATION PROCEDURES
2.6.1 Installing the BIS M-620-068-A01-00-S_ RS232
Figure 27 - RS232 Typical Layouts
The BIS M-620-068-A01-00-S_ Processor unit is designed for point-to-point RFID
applications, where the distance from host to processor unit is less than 15 meters (50 feet).
The processor unit connects directly to a serial communications port on a host computer via
an RS232-compatible serial interface cable.
1. Select a suitable location for the BIS M-62_ Processor unit/Antenna.
2. Mount the BIS M-37_ antenna to the BIS M-62_ Processor unit, either directly or
remotely, as described in par. 2.2.
3. Mount the processor unit and antenna to your mounting fixture using M5 (or #10)
diameter screws ( not included ) and secure them with appropriate washers and nuts.
Tighten screws to 1.7 Nm or 15 lbs per inch ± 10% .
4. Connect the BCC0H0W M12 8-pin female connector to the M12 8-pin male interface
connector on the BIS M-62_. Connect the BCC0H0W 9-pin female D-sub connector to an
RS232 COM port on the host computer.
Tighten the cable’s two locking thumbscrews.
5. Connect the power supply to the VDC (red) and GND (black) wires on the BCC0H0W
cable.
6. Apply power to the processor unit after all cable connections have been made. The LEDs
on the unit will flash. The READY LED is ON after the power up sequence has
completed.
7. On the host computer, set the COM port parameters to: 9600 baud, 8 data bits, 1 stop bit,
no parity and no handshaking.
To verify operations, download the
Balluff Dashboard™ Configuration Tool from
www.balluff.com . The
Balluff Dashboard™ Configuration Tool allows users to configure and
control their BIS M-620-068-A01-00-S_ processor units and send RFID commands for
testing purposes.
See the Dashboard™ Manual for details.
BIS M-620-068_ w antenna
BCC0H0W
Host
Power Supply
VDC (red)
GND (black)