Balluff BAM MD-VS-001-0002, Operation Manual

Page: 241 / 314

241
www.balluff.com
4
References
Balluff BVS HS-P Family
Industrial Handheld Barcode Readers
NAK Character This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
1 Determine the desired character or value.
2 Use the ASCII Chart on the inside back cover of this manual to find the hex equivalent for the
desired character/value.
3 Go to page 40 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4 Scan the barcode: SELECT NAK CHARACTER SETTING.
5 Scan the appropriate two alphanumeric characters from the keypad in Appendix D: Keypad ,
that represent the desired character/value in step 1 above. The second character will cause a
two-beep indication.
6 Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See Table NAK Character Setting Examples for some examples of
how to set this feature.
NAK Character
Setting
Examples
NOTE
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-bit
data is not recognized when the option
Data Bits has been set as 7
Data Bits.
STEP ACTION EXAMPLES
1
Desired Character/
Value
NAK $ @ >
2
Hex equivalent from
fig.
10 ASCII Chart
ASCII Chart
0x15 0x24 0x40 0x3E
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT NAK CHARACTER SETTING
5
Scan Two Characters
From
Appendix D:
Keypad
‘1’ and ‘5’ ‘2’ and ‘4’ ‘4’ and ‘0’ ‘3’ AND ‘E’
6 Scan ENTER/EXIT PROGRAMMING MODE