37
37
E
Function displays
on BIS C-6_2
The BIS C-6_2 uses the three side-mounted LED's to indicate important conditions of the
identification system.
Status
LED
Meaning
System Ready
on (green)
Supply voltage OK; no hardware error.
off
Supply voltage/hardware not OK,
or cable break to read/write head or not connected.
Codetag Present
on (yellow)
Data carrier read/write-ready (if a read/write error
occurs
during a read or write, the System Ready LED goes off).
flashes
Cable break to read/write head or not connected.
off
No data carrier in read/write range.
Codetag Operating on (yellow)
Read/write command in process.
off
No read/write command in process.
If all three LED's are on, it means a memory error. The unit must be returned to the factory.
LED Display
C6_2-019_641365_0506-e.p65
38
38
E
Mounting the
BIS C-602 processor
and orientation of
the read/write head
or adapter
BIS C-602
Mounting Processor / Head
The processor is attached using 4 lateral mounting holes.
Depending on model, the
processor is equipped
with a read/write head or
the adapter for offset
read/write heads. Both
the read/write head and
the adapter can be
rotated by the user by
+ or –90 deg. to the
desired position (see
drawing). Be sure that
power is off first. Loosen
both screws (indicated
with arrows). Carefully
pull the head or adapter
out towards the side
(direction of arrow, right
drawing).
Caution: wires inside!
Reattach at the desired
orientation and screw
tight again.
Caution:
wires inside!
