WALL MOUNTING INSTRUCTIONS
300mm(12inch)
150mm(6inch)
150mm(6inch)
150mm(6inch)
Note:
1.The appliance must not be located inmediately below a socket outlet.
2.Your Panel Heater should be installed with at least 150mm clearance from the floor
and any other surrounding parts including other appliances and side walls.At least
300mm clearance from ceilings, shelves and so� furnishings.
3.Do not run the power cord behind the heater.
05
WALL MOUNTED HEATERS
AREONLY TO BE MOUNTED ON
HEATRESISTANT WALLS THAT
COMPLYWITH CURRENT
SPECIFICATIONS & BUILDING
REGULATIONS
WALL MOUNTED
1. Make sure the appliance is unplugged and power switches are off.
2. Posi�on the panel appliance within one metre of wall socket. Do not mount in
front of orbelow the wall socket. Ensure there is at least 150mm clearance on all
sides of the appliance.
3. Posi�on the moun�ng bracket in the wall and mark the hole posi�ons with a pen
or pencil and check they are horizontal with a spirit level. Ensure the two bo�om
mount holes are at least 150mm from the floor and drill holes as required.
4. Secure the moun�ng bracket to the wall with the moun�ng screws. (For masonry
walls use the plas�c sheaths).
5. Insert the back of the device into the moun�ng bracket. First find the bo�om plug,
align and insert it, then align the upper hole and push it toward the wall. You can
press down on the protruding part above the bracket so that the bracket slot can
be�er enter the hole posi�on.
6. Plug appliance into a standard 120 volt AC electrical outlet.
