Ballu KFR-2501G/Y2BPE, Service Manual

Page: 52 / 70

KFR-2601G/BPE*2
11. DISASSEMBLY INSTRUCTIONS
51
1. Remove the grille
1) Open the screw cover of the grille.
2) Take out the screws of the grille.
3) Hold both sides of the grilleand drag it towards oneself,
shown the operation switching board of the indoor unit.
2. Remove the electrical control box
1) Remove the cover of the electrical control box
2) Take the indoor coil sensor from the sensor bracket.
3) Remove the switching board.
4) Take out the screws of the terminal board and remove the
terminal board.
5) Disconnect the circuitry of the printed circuit board.
6) Remove and check-up the printed circuit board.
7) Disconnect all the connectors of the electrical control box.
8) Take out the screws of the electrical control box and
remove the electrical control box.
2. Remove the installation plate
1) Take out the screws of the installation plate.
2) Remove the installation plate.
Screws
Screws
Installation Platel
Terminal Board
Screws
Printed Circuit Board
Sensor Bracket
Screws
Front Panel