Receiving & Installation 2-7
MN1272
5.
Select “Binary Transfers” from the Settings pull down menu within
Terminal program.
6.
Set the Binary Transfer protocol to XModem/CRC.
7.
Close menu and save the settings.
8.
Terminal Communications settings are now complete.
Windows 98
1.
Power up the Host and start Windows software.
2.
In “Control Panel” select and open “System”.
3.
Open “Ports”, select the COM port you are using then click “properties”.
Figure 2-9
4.
Be sure the port settings are as: Bits per second=9600, Data bits=8,
Parity=none, Stop bits=1 and Flow control=Xon/Xoff.
Windows NT/2000
1.
Power up the Host and start Windows software.
2.
In “Control Panel”, select and open “Ports” then click “Settings”.
Figure 2-10
3.
Be sure the port settings are as: Bits per second=9600, Data bits=8,
Parity=none, Stop bits=1 and Flow control=Xon/Xoff.
When software and hardware installations are complete, refer to MN1271 HMI
Software manual for instructions on how to program the panel.