Section 1
General Information
Programming & Operation 4-9
MN715
Security System Changes
Access to programmed parameters can be protected from change by the security code
feature. The Security Code is defined by setting the Level 2 Security Control block. To
implement the security feature, use the following procedure:
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
Display mode. Stop LED on.
Press PROG key
Enter program mode.
Press
or
key
Scroll to Level 2 Blocks.
Press ENTER key
Access Level 2 Blocks.
Press
or
key
Scroll to the Security Control
block.
Press ENTER key
Access the Security Control
block.
Press
key
Scroll to the Access Code
parameter.
Press ENTER key
The Access Code parameter can
be changed.
represents blinking cursor.
Press
key
Use
key to change value.
Example: 8999.
represents blinking cursor.
Press ENTER key
Save Access Code parameter
Keypad Display will not show user
access code. Record its’ value
for future reference.
Press
key
Scroll to Security State.
Press ENTER key
Access Security State parameter.
represents blinking cursor.
Press
key
Select Local Security.
Press ENTER key
Save selection.
P: will change to L: after returning
to display mode for longer than
time set in Access Time
parameter.
Press DISP key
Return to Display mode.
Typical display mode.
Note: Please record your access code and store it in a safe place. If you cannot
gain entry into parameter values to change a protected parameter, please
contact Baldor. Be prepared to give the 5 digit code located on the lower right
side of the Keypad Display at the Enter Code parameter prompt.
