Section 1
General Information
4-6 Programming & Operation
MN715
Initialize New Software EEPROM
After a new EEPROM is installed, the control will automatically initialize the new software
version and memory locations as if “STD Settings” was selected. If you need to initialize
the control to the 50Hz / 400Volts” settings, use the following procedure.
Note: All parameter values already programmed will be changed when resetting the
control to factory settings.
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
Display mode. Stop LED on.
Press PROG key
Enter program mode.
Press
or
key
Scroll to Level 2 Blocks.
Press ENTER key
Select Level 2 Blocks.
Press
or
key
Scroll to the Miscellaneous block.
Press ENTER key
Select Miscellaneous block.
Press
key
Scroll to Factory Settings
parameter.
Press ENTER key
Access Factory Settings
parameter.
represents blinking cursor.
Press
key
Scroll to STD SETTINGS, to
choose original factory settings.
For 50Hz motors, set to
50Hz/400 VOLTS.
Press ENTER key
Restores factory settings.
“Loading Presets” is first message
“Operation Done” is next
“No” is displayed last.
Press
key
Scroll to menu exit.
Press ENTER key
Return to display mode.
Display mode. Stop LED on.
Press DISP key
Scroll to diagnostic info block.
If you wish to verify the software
version, enter diagnostic info.
Press ENTER key
Access diagnostic information.
Displays commanded speed,
direction of rotation, Local/
Remote and motor speed.
Press DISP key
Display mode showing software
version and revision installed in
the control.
Verify new software version.
Press DISP key
Displays exit choice.
Press ENTER to exit diagnostic
information.
