Section 1
General Information
Programming & Operation 4-7
MN715
Operation Examples
Operating the Control from the Keypad
If the control is configured for remote or serial control, the LOCAL Mode must be
activated before the control may be operated from the keypad. To activate the LOCAL
Mode, first the motor must be stopped using the keypad STOP key (if enabled), remote
commands or serial commands.
Note: Pressing the keypad STOP key (if enabled) will automatically issue a motor
stop command and change to LOCAL mode.
When the motor has stopped, the LOCAL Mode is activated by pressing the “LOCAL”
key. Selection of the LOCAL Mode overrides any remote or serial control inputs except
for the External Trip input, Local Enable Input or STOP input.
The control can operate the motor in three (3) different ways from the keypad.
1.
JOG Command.
2.
Speed adjustment with Keypad entered values.
3.
Speed adjustment using the Keypad arrow keys.
Note: If the control has been configured for Keypad in the operating mode
parameter (level 1, input block), then no other means of operation is permitted
other than from the keypad.
Accessing the Keypad JOG Command
Action
Description
Display
Comments
Apply Power
Keypad Display shows this
opening message.
Logo display for 5 seconds.
If no faults and programmed for
LOCAL operation.
Display mode. Stop LED on.
Press JOG key
Access programmed JOG speed.
JOG key LED on.
Press and hold FWD or
REV key
Move control forward or reverse
at JOG speed.
Control runs while FWD or REV
key is pressed. JOG & FWD (or
REV) LED’s on.
Press JOG key
Disables JOG mode.
JOG LED off.
Stop key LED on.
