TP700
USER GUIDE
42370 Rev A
15
14
Balboa Water Group | Your Single Source Solution
AUXILIARY PANELS
Specific Buttons for Specific Devices
If the spa has any auxiliary panel(s) installed, pressing
a button on such panel(s) will activate the device
indicated for that button. These dedicated buttons will
operate just like the Spa Screen buttons (view page 13).
ADJUSTING
FILTRATION
Circulation Pump Modes
Some spas may be manufactured with Circulation
Pump settings that allow programming filtration cycle
duration. Some Circulation Modes are pre-programmed
to operate 24 hours a day and are not programmable.
Refer to the spa manufacturer’s documentation for any
Circulation Pump Mode details.
Purge Cycles
In order to maintain sanitary conditions, as well as
protect against freezing, secondary water devices will
purge water from their respective plumbing by running
briefly at the beginning of each filter cycle. (Some
systems will run a certain number of purge cycles per
day, independent of the number of filter cycles per day.
In this case, the purge cycles may not coincide with the
start of the filter cycle.)
If the Filter Cycle 1 duration is set for 24 hours, enabling
Filter Cycle 2 will initiate a purge when Filter Cycle 2 is
programmed to begin.
The Meaning of Filter Cycles
1. The heating pump always runs during the filter cycle*
2. In Rest Mode, heating only occurs during the
filter cycle
3. Purges happen at the start of each filter cycle
(on most systems).
* For example, if your spa is set up for 24-hour
circulation except for shutting Off when the water
temperature is 3˚F/1.5˚C above the set temperature,
that shutoff does not occur during filter cycles.
Model #: AX10
Model #: AX20
Model #: AX40
Auxiliary Panels
A
B
Keep your water clean and
ready to enjoy!
Follow these steps to set the Filter Cycles:
1 - Navigate to Filter (A).*
2 - Press the SELECT navigation button to view the
Filter screen (B).
3 - Select the start time for Filter Cycle 1 (C). Press the
SELECT navigation button to view the time controls (E).
4 - Enter your time settings (E) with the
navigation buttons.
5 - Select the Save button (D), and press the SELECT
navigation button.
You have set the start time for Filter Cycle 1.
If you do not want to save your settings, select the
Cancel button (F), and press the SELECT
navigation button.
6 - Follow the same process to change the other Filter
time settings if desired.
7 - Once all of the time changes are set, select the Save
button (G), and press the SELECT navigation button.
You have set all of the Filter Cycle times.
How can you tell if Filter Cycle 2 is enabled?
Filter Cycle 2 is enabled when a white ring appears
around the 2 (H). In this example there is no white ring,
so Filter Cycle 2 is disabled. Filter Cycle 2 is disabled by
default on many spas.
SET FILTER
CYCLE TIMES
F
C
D
H
G
E
* View page 10 for information on navigating the Settings menu.
