59
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
42211 C
SYSTEM INFORMATION
The System Information Menu displays various settings and
identification of the particular system. As each item in the menu
is highlighted, the detail for that item is displayed at the bottom
of the screen.
SOFTWARE ID: (SSID)
Displays the software ID number for the System.
SYSTEM MODEL
Displays the Model Number of the System.
CURRENT SETUP
Displays the currently selected Configuration Setup Number.
CONFIGURATION SIGNATURE
Displays the checksum for the system configuration file.
HEATER VOLTAGE (FEATURE NOT USED ON CE
RATED SYSTEMS.)
Displays the operating voltage configured for the heater.
HEATER WATTAGE AS CONFIGURED IN SOFTWARE
(CE SYSTEMS ONLY)
Displays a heater kilowatt rating as programmed into the control
system software (1-3 or 3-6).
HEATER TYPE
Displays a heater type ID number.
DIP SWITCH SETTINGS
Displays a number that represents the DIP switch positions of S1
on the main circuit board.
PANEL VERSION
Displays a number of the software in the topside control panel.
HEATER RELATED MESSAGES
THE WATER FLOW IS LOW – M016
There may not be enough water flow through the heater to carry
the heat away from the heating element. Heater start up will
begin again after about 1 min. See “Flow Related Checks” below.
THE WATER FLOW HAS FAILED* – M017
There is not enough water flow through the heater to carry the
heat away from the heating element and the heater has been
disabled. See “Flow Related Checks” below. After the problem
has been resolved, you must press any button to reset and begin
heater start up.
THE HEATER MAY BE DRY* – M028
Possible dry heater, or not enough water in the heater to start
it. The spa is shut down for 15 min. Press any button to reset the
heater start-up. See “Flow Related Checks” below.
THE HEATER IS DRY* – M027
There is not enough water in the heater to start it. The spa
is shut down. After the problem has been resolved, you must
clear the message to restart heater start up. See “Flow Related
Checks” below.
THE HEATER IS TOO HOT* – M030
One of the water temp sensors has detected 118°f (47.8°C) in the
heater and the spa is shut down. You must clear the message
when water is below 108°f (42.2°C). See “Flow Related Checks”
below.
FLOW-RELATED CHECKS
Check for low water level, suction flow restrictions, closed
valves, trapped air, too many closed jets and pump prime.
Note: On some systems, even when spa is shut down by an error
condition, some equipment may occasionally turn on to * or if
freeze protection is needed.
TP800, TP900 Sensor and System Related Messages
Back
System Information
Software ID (SSID)
System Model
Current Setup
Configuration Signature
Heater Voltage
Heater Type
Software ID (SSID):
M100_101 V0.6
