INSTALLATION
SETUP/PHYSICAL INSTALLATION
2 - 6
I-E96-409A
®
2. If round type cables are already installed in the termination
mounting unit (TMU), remove the cable retaining bracket.
3. If the NKTU02 or NKTU12 cable is used, insert the J2 end
of the cable into the MMU backplane slot assigned to the mas-
ter/slave module. If the NKTM01 cable is used, insert one end
of the cable into the MMU backplane slot assigned to the mas-
ter/slave module. The cable should latch securely in place.
Card edge connector P3 of the master/slave module connects
to this end of the cable.
4. If the NKTU02 or NKTU12 cable is used, connect the shield
wire extending from the J2 end of the cable to the shield bus.
5. If the NKTU02 or NKTU12 cable is used, insert the J1 end
of the cable into the TMU backplane slot assigned to the ICS
module. If the NKTM01 cable is used, insert the unused end of
the cable into the TMU backplane slot assigned to the ICS
module. The cable should latch securely in place. Card edge
connector P1 of the ICS module connects to this end of the
cable.
6. Insert the master/slave module in the module mounting
unit until it locks into place.
7. Replace or add the cable retaining bracket if round type
cables are installed in the termination mounting unit.
NKTD02, NKTD12
This cable connects the ICS module to a single NDCS03,
NDIS01, or IISAC01 station. Install the cable as follows:
1. Remove the NDIS01, NDCS03, or IISAC01 station from the
station housing.
2. Insert the J2 end of the cable into the station housing
backplane. Viewing the station from the back, the cable inserts
into the right slot (use the left slot for an NDCS03 station with
analog output bypass capability). The cable should latch
securely into place. Card edge connector P1 of the station cir-
cuit board connects to this end of the cable.
3. Insert the J1 end of the cable into the J2 connector of the
ICS module. The cable should latch securely into place.
4. Install the NDIS01, NDCS03, or IISAC01 station into the
station housing.
