INSTALLATION
SETUP/INSTALLATION
2 - 4
I-E96-405A
®
Figure
for the cable connections from the termination
unit to the slave modules. Table
lists the NTAI04 cable
applications.
Make connections to the TU after it is mounted in the field ter-
mination panel. To install the TU cable follow these steps.
1. Insert the hooded end of each cable into the module
mounting unit backplane slot assigned to the slave modules.
The cables should latch securely in place. Card edge connector
P3 of the slave module connects to this end of the cable.
2. Insert the male 36 pin connector end of the cable from the
first slave module into the P1 connector of the TU. The cable
should latch securely in place.
3. Insert the 36 pin connector end of the cable from the sec-
ond slave module into the P2 connector of the TU. The cable
should latch securely in place.
CAUTION
Remove modules from their multibus module unit slots before
installing or removing a cable assigned to that slot. Failure to
do so could result in damage to the module.
ATTENTION
Retirer les modules de leur position assignée avant d'installer
un câble à cette position. Des dommages au module ou au
poste pourraient résulter d'un manquement à cette procédure.
Figure 2-2. Cable Connections for NTAI04
T00470A
P1
P1
P3
P3
P3
P2
P1
P2
P2
NTAI04
IMASM03/04
IMASM03/04
NKTU01/11
NKTU01/11
