Bailey Approach SE, Owner'S Manual

Page: 60 / 96

7-13
FITTED EQUIPMENT
STAINLESS STEEL SINK
Stainless steel sinks need little maintenance
other than cleaning immediately after use.
Most deposits can be removed by washing
with soap or mild detergent and hot water,
followed by a clean water rinse and drying
with a soft cloth to prevent water spotting.
For more tenacious deposits a non-abrasive
multi-purpose cream cleaner such as CIF
should be used, followed by a clean water
rinse and drying.
Tannin stains can be removed by a solution
of washing soda and water applied with a soft
cloth/sponge followed by a clean water rinse
to remove any residues and drying with a soft
cloth. (When cleaning with anything other
than water be careful not to get the solution
onto your kitchen worktop.)
Scratching will be most noticeable on highly
polished components. These marks are
usually only superficial and can be removed
with a proprietary stainless steel cleaner/
polish. A useful alternative is a car paint
restorer, such as ‘T-Cut’. If the surface has a
directional polished grain always clean along
the grain and not across it.
Always avoid bleach and trigger dispense
products and never use wire wool or leave
wet cloths, pads or containers on the surface
as they may form water marks.
To preserve the appearance of your
appliance we recommend plastic bowls
or mats are not stored in the sink. This is
particularly the case when travelling because
vehicle movement may cause the plastic
bowl to vibrate/rub against the surface and
leave marks.
TAPS
To clean, wipe with a soft soapy sponge, then
rinse and wipe dry. Do not use an abrasive
cleaner, scouring pad, powder or wire tool to
clean the tap and shower mixer. Do not use
any de-scaling agent.
If you live in a hard water area, lime scale
may build up around the spout of your tap.
Clean this off with either lemon juice or
vinegar. Do not attempt to remove this with
either a knife or any other sharp implement
as this will damage the surface.
Winterising
Freezing in winter may cause damage to the
Whale tap.
To avoid this damage, ensure that the system
is completely drained.
• Drain the fresh water tank either using
the pump or a drain valve.
• Turn the pump on and open all taps and
the shower mixer (including the drain
valve) and allow the pump to purge the
water from the system.
• Turn off the power isolator switch for the
water pump.
• Remember to leave all outlets open to
avoid any damage.
• Lift the lever up of every tap and leave it
in its central position.