Bailey ADVANCE 2019, Owner'S Manual

Page: 35 / 178

31
SETTING UP UPON ARRIV
AL
SETTING UP UPON ARRIVAL
S
iting your motorhome
The following are brief, but not exhaustive,
instructions on how to initially set up your
motorhome when you have arrived at your
destination.
Report to reception for information about the
site rules and carefully select where you wish
to park your motorhome
The site should be as level as possible, well
drained and away from boggy areas, and
preferably not under or near to trees.
Consider how you will move your motorhome
when you are leaving site; for example on
sloping ground in wet conditions, pitch facing
downhill.
Where possible leave 6 metres (20ft) of free
space around your vehicle.
l
evelling
y
our
m
otorhome
It is important to site your motorhome level
so as to ensure the correct operation of the
refrigerator, cooker, microwave etc.
Always use motorhome specific ramps rated
for the weight of your vehicle.
m
ainS
p
ower
c
onnection
Connect the 230v to the motorhome by
plugging your 3 pin lead into the site supply
and the 230v socket situated on the outside
of your motorhome. Always test the circuit
breaker on the PDU.
g
aS
S
upply
1. Open the cylinder valve.
2. Firmly press the hose rupture protection
(green button) on the high-pressure hose for
about 5 seconds.
3. If necessary (e.g. after a new installation or
inadvertently striking the gas cylinder against
the gas pressure regulation system), press the
green reset button (crash sensor triggering
element reset) on the MonoControl CS for
about 5 seconds.
Turn on all the taps at the manifold (located in
the kitchen) which are labelled and serve the
individual appliances. Please bear in mind that
if there is still some air in the supply pipes the
ignition of gas equipment may take longer than
usual.