Bailey Moyes 912 Dragonfly, Maintenance Manual

Page: 78 / 191

Page 77
Section 28
Maintenance & Inspection
Dragonfly 582/912
ELECTRICAL SYSTEM
STEP INSTRUCTIONS
for Assembly, for Disassembly reverse the order!
PART NO. STAGE CERT.
1
Mount the battery bracket ,
on the root tube.
DFL 023
2 Install rubber cushion pad in bottom of battery bracket.
3 Fit battery into position and use a wing strap to buckle the battery into
position.
4 Mount the solenoid switch on root tube
5 Mount the regulator rectifier on root tube.
6 Mount the 10 terminal connector block on the port side of the root tube.
7 Mount the switch panel on under side of the root tube.
8 Connect battery cables to solenoid switch and starter motor, negative to
ground and engine. Run all cables on Starboard side of the root tube.
(Fuel Lines are on Port Side of Root Tube.)
9 Connect seven core cable to engine connector plugs and terminal block
10 Connect switch panel to Engine Connectors.
11 Connect Engine senders to Engine Connectors (Drawing 28b)
12 Connect EIS to Engine Connectors (Drawing 28b)
(1) Recommended Special Tools: None
(2) The parts needed to perform the task: Replace worn/damaged parts as needed, listed above. Max. Wear (defined 1.1.8.1)
(3) Type of maintenance: Inspection=Line (replacement of fuses, etc..) & Replacement=Heavy
(when it involves replacement
of structural components.) & all Electrical Components and Wiring.
(4) Certification needed to accomplish the task: Line=LSRI Inspection or above, Heavy=LSRM Maintenance or above.
see:
3 Level of Certification in this manual
(5) Detailed instructions and diagrams as needed to perform the task, listed above and adjacent page.
Every Annual or 100 Hrs., Inspect for Cracks, Corrosion, Elongation of holes & Fasteners for Wear & Security.
(6) Method to test/inspect to verify the task was accomplished properly. Insure that all procedures were followed correctly
and there is proper non-binding movement to moving parts and that fasteners were tightened as instructed. When flight
controls are involved, assure that they are operating properly.
Section 28 Electrical System
Section 28