Baileigh TN-800, Operator'S Manual

Page: 21 / 44

19
19
OPERATION
Cutter Selection
1. Before any notching can take place, the
proper cutter must be chosen. If the material
to be notched is 1" (25.4mm) diameter up to
3" (76.2mm) diameter, the supplied 1"
(25.4mm) cutter will work properly.
2. If the material is smaller than 1" (25.4mm),
then an optional reducer bushing and 1/2"
(12.7mm) diameter cutter must be installed.
(This will notch from 1/2" (12.7mm) up to 1"
(25.4mm) diameter material.
3. To install the cutter, first unplug the power
cord and open the Lexan guard.
4. Loosen the set screws (A) located on the
spindle and insert the desired cutter, align
the flats on the cutter with the holes on the
spindle.
5. Tighten the set screws (A).
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
WARNING:
BEFORE THE MAIN LEXAN GUARD IS OPENED, THE
POWER CORD MUST BE UNPLUGGED FROM ITS SOURCE.
A