Baileigh TN-800, Operator'S Manual

Page: 27 / 44

25
25
TROUBLESHOOTING
Problem Solution
Chattering
Material too far out past vise
Material not clamped tight in vise
Vise lock lever is too loose
Cutter is dull or loose
"X","Y" table gibs set too loose
"V" rollers set too loose
Motor stops while notching
Feeding to fast
Cutter is dull
Not a good power source, circuit should be
dedicated to this machine only
Main handwheel is tight or sticks in
spots
Chips are stuck in the "v" rollers
"V" rollers are set too tight, The "V" roller can be
adjusted
WARNING:
Make sure the electrical disconnect is OFF before working on
the machine.