10
10
24.
Keep children away
. Children must never be allowed in the work area.
DO NOT
let them
handle machines, tools, or extension cords.
25.
DO NOT operate machine if under the influence of alcohol or drugs
. Read warning
labels on prescriptions. If there is any doubt,
DO NOT
operate the machine.
26.
DO NOT
touch live electrical components or parts.
27.
Be Sure
all equipment is properly installed and grounded according to national, state, and
local codes. If machine is equipped with a three-prong plug, it should be plugged into a
three-hole electrical receptacle. If an adapter is used to accommodate a two-prong
receptacle, the adapter plug must be attached to a known ground. Never remove the third
prong.
28. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed.
Bare wiring can kill!
29.
Maintain machine in top condition
. Keep clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
30.
Reduce the risk of unintentional starting
. Make sure switch is in
“OFF”
position before
plugging in power cord.
31.
Never leave machine running unattended. TURN POWER OFF
. Don’t leave machine until
it comes to a complete stop.
32.
DO NOT Perform Any Operation Freehand.
Use the fence for straight shaping, the miter
gauge for end shaping, and a starting pin and collar for curve shaping.
33.
Push Blocks.
Push blocks or push sticks should be used in situations where it is necessary
to push the piece part against the fence.
34.
AVOID
awkward operations and hand positions where a sudden slip could cause your hand
to move into the spinning cutter causing
serious personal injury
.
35.
Cutter Height.
Keep any unused portion of the shaper cutter below the surface of the table.
36.
Sand Appropriate Material.
Only use this spindle shaper sander for natural wood stock. It is
NOT
recommended to sand particle board, plastics, laminates, medium-density fibre board
(MDF), metal, glass, ceramics, or products containing asbestos or lead paint. Some of these
materials contain hazardous dust and will shorten the life span of the sanding spindle.
37.
Warning
: The dust generated by certain woods and wood products can be injurious to your
health. Always operate machinery in well ventilated areas and provide for proper dust
removal. Use a wood dust collection system whenever possible.
Summary of Contents for SS-3528-S
