24
24
FENCE ASSEMBLY
Align the Fence Parallel to the Blade
1. Disconnect and lockout power to the saw!
2. Slide the fence over to the right T-slot on the saw
table top.
3. Lock down the fence handle and make a visual
check that the fence is parallel with the T-slot along
the entire length. Also, you can place a small 3/4”
thick block of wood, upright into the T-slot and slide
it from the front to the back checking its distance
from the left edge of the fence.
1. If the fence is not parallel, it can be adjusted by
using an Allen wrench to turn one or both of the
screws (C) or (D). Do this slowly, just an eighth to a
quarter turn at a time, or you will quickly overshoot
the desired adjustment.
Note:
It is always good practice to
periodically recheck the alignment of your fence to the
blade.
Note
: The photos and illustrations used in this manual are representative only and
intended to illustrate technique only.
WARNING:
The rip fence must be parallel to the blade during operation.
Failure to set the rip fence parallel to the blade can result in kickback and possible
serious injury.
