27
27
Riving Knife and Guard Installation
1. Before installing onto the saw, the anti- kickback
pawl (E) must be separated from the riving knife
(H).
2. Press and hold the quick-release button (D) on the
base of the anti-kickback pawl (E) and lift the pawl
to remove from the riving knife (H).
Installation
1. Set the saw blade to the 90° position and raise it all
the way up.
2. Remove the table insert (J).
3. Located inside the table and accessible through the
insert opening, place the quick-release clamp lock
handle (K) in the unlock position.
4. The floating clamp block (L) is spring loaded and
will move away (O) from the fixed block (M), leaving
a gap.
5. Insert the bottom of the riving knife (N1, N2) all the
way into the gap between the clamp blocks (L, M);
then lock the handle (K).
6. Replace the table insert (J) back on the table. The
saw blade and riving knife should protrude through
the slot in the insert.
7. Attach the anti-kickback pawl (E) by pressing and holding the quick-release button (D) and
inserting the lock pin of the pawl into the appropriate slot (F) on the riving knife.
CAUTION:
After changing a saw blade, always check that the Riving
knife or Blade Guard is correctly set!
